[Monitor Duox Iris] Programming monitor IRIS 4.3"
Written by Ping-En Shih
Updated at November 16th, 2026
Ref. 9256/9257/9258/9259
Option 1: With the doorbell:
*Only for a monitor WITHOUT the programmed address.
- While at rest, press the doorbell (joining the T and “-”) for 5 seconds. A confirmation beep will be heard on the monitor. The monitor will automatically connect with the Placa activating the camera.
Optionally, you can establish audio communication with the Placa to indicate which residence you are at. To do this, press the CONVERSATION button.
- In less than 2 and a half minutes, enter the call code for that monitor from the Placa. Depending on the type of Placa installed:
a. Pressing the corresponding button
b. Entering the code + bell.
- A different ringing tone will occur, confirming the programming of the monitor and the camera image will continue to be displayed.
Option 2: From the monitor:
Accessing the programming menu:
*This menu will only be available after the first programming.

- Press the buttons multifunction 1 and 4 at the same time to access the Installer Menu.
- Press the button multifunction 3 to select the PRG icon.
- Press the button multifunction 4 to access the programming menu.
Once in the programming menu:

- Press the button multifunction 4 to select the PRG FROM MONITOR icon.
- Press the button multifunction 2 (< : Shift 1 position to the left to modify each digit) or multifunction 3 (+ : Increase the current position value by 1. If 9 then pressing +, goes back to 0).
- Press the button multifunction 4 to confirm the address.
Option 3: From the Placa:
*The Placa from which programming is done must be set as master Placa.
- From the same menu mentioned in the previous section, press the button multifunction 3 to switch from the PRG FROM MONITOR icon to PRG FROM PLACA. The monitor will automatically connect with the street Placa activating the camera.
Optionally, you can establish audio communication with the street Placa to indicate which residence you are at. To do this, press the button CONVERSATION.
- In less than 2 and a half minutes, enter the call code for that monitor from the Placa. Depending on the type of Placa installed:
a. Pressing the corresponding button
b. Entering the code + bell.
- A different ringing tone will occur, confirming the programming of the monitor and the camera image will continue to be displayed.
Option 4: With the decoder:
*Refer to the detailed information at www.fermax.com, consulting references 9419 and 9425.
After 30 seconds, the monitor returns to rest.
Once the address of the monitor is programmed, it is indicated by the POWER led being on.
Download Article