• Contact Us
English (US)
ES Spanish
GR Greek
PL Polish
DE German
US English (US)
PT Portuguese
NL Dutch
FR French
RU Russian
IT Italian
  • Home
  • DUOX
  • Monitors
  • Shared functions on duox monitors

[Monitor Duox Iris] Programming monitor IRIS 4.3"

Written by Ping-En Shih

Updated at November 16th, 2026

  • MEET
    Monitors Panels Guard Unit Others
  • DUOX
    Monitors
+ More

Ref. 9256/9257/9258/9259

Option 1: With the doorbell:   

  *Only for a monitor WITHOUT the programmed address.

  1. While at rest, press the doorbell (joining the T and “-”) for 5 seconds. A confirmation beep will be heard on the monitor. The monitor will automatically connect with the Placa activating the camera.

       Optionally, you can establish audio communication with the Placa to indicate which residence you are at. To do this, press the CONVERSATION button.

  1. In less than 2 and a half minutes, enter the call code for that monitor from the Placa. Depending on the type of Placa installed:

         a. Pressing the corresponding button

         b. Entering the code + bell.

  1. A different ringing tone will occur, confirming the programming of the monitor and the camera image will continue to be displayed. 
 
 

Option 2: From the monitor:

Accessing the programming menu:

*This menu will only be available after the first programming.

  1. Press the buttons multifunction 1 and 4 at the same time to access the Installer Menu.
  2. Press the button multifunction 3  to select the PRG icon.
  3. Press the button multifunction 4 to access the programming menu.

Once in the programming menu:

  1. Press the button multifunction 4 to select the PRG FROM MONITOR icon.
  2. Press the button multifunction 2 (< : Shift 1 position to the left to modify each digit) or multifunction 3 (+ : Increase the current position value by 1. If 9 then pressing +, goes back to 0).
  3.  Press the button multifunction 4 to confirm the address.
 
 

Option 3: From the Placa:

*The Placa from which programming is done must be set as master Placa.

  1. From the same menu mentioned in the previous section, press the button multifunction 3 to switch from the PRG FROM MONITOR icon to PRG FROM PLACA. The monitor will automatically connect with the street Placa activating the camera.

        Optionally, you can establish audio communication with the street Placa to indicate which residence you are at. To do this, press the button CONVERSATION.

  1. In less than 2 and a half minutes, enter the call code for that monitor from the Placa. Depending on the type of Placa installed:

         a. Pressing the corresponding button

         b. Entering the code + bell.

  1. A different ringing tone will occur, confirming the programming of the monitor and the camera image will continue to be displayed. 
 
 

Option 4: With the decoder:

*Refer to the detailed information at www.fermax.com, consulting references 9419 and 9425.

 
 

After 30 seconds, the monitor returns to rest.  

Once the address of the monitor is programmed, it is indicated by the POWER led being on.

monitor setup aris configuration

Download Article

Table of Contents

Option 1: With the doorbell: Option 2: From the monitor: Option 3: From the outdoor panel: Option 4: With the decoder:

Related Articles

  • NEO Monitor Installer
  • [Monitor Duox Iris] Installation

For more information, visit www.fermax.com
Contact: tec@fermax.com www.fermax.com/contact

Fermax logo

FERMAX ELECTRONICA S.A.U

Avenida Tres Cruces, 133
46017 Valencia, Spain

Expand